Automatic ATS switching operation steps of Diesel generator set

There are 2 kinds of ATS automatic electric cabinet operation methods.
    1, module manual operation mode:
    After turning on the power key, press the “Manual” button of the module to start directly. When the unit starts successfully and normal operation, at the same time, the automation module also enters the self-test state, it will automatically enter the speed-up state. After the speed increase is successful, the unit will be based on the module. The display enters the automatic closing and grid connection.
   2, fully automatic operation mode:
   Set the module in the "automatic" position, the unit enters the quasi-start state, and in the automatic state, through the external switch signal, the mains state is automatically detected and judged for a long time. Once the mains fails or loses power, it will enter the auto start state immediately. When the mains calls, it will automatically switch to the off-speed and stop. When the mains returns to normal, the system will automatically trip to the network after 3S confirmation, delay 3 minutes, automatically stop, and automatically enter the next automatic start preparation state.
    First turn on the power key and press the “Auto” button directly. The unit will automatically start the speed increase at the same time. When the Hertz meter, the frequency meter and the water temperature meter display normally, he will automatically close the power transmission and the grid connection. Quasi-state automatic control, automatic detection of mains status, automatic start of unit, automatic network, automatic retreat, automatic stop, automatic trip, shutdown, alarm.